User Manual

26
POWER
AUTO ADJUST
PC CARD
LAMP
STATUS
ON/STAND BY
SOURCE3D REFORM
3. Projecting an Image (Basic Operation)
 Selecting a Source
Selecting the computer or video source
Using the Remote Control
Press any one of the COMPUTER 1/2/3, Component, VIDEO, S-VIDEO, VIEWER
or LAN buttons.
NOTE: The COMPUTER 3 button is not available for LT280.
Detecting the Signal Automatically
Press and hold the SOURCE button for a minimum of 1 second, the projector will
search for the next available input source. Each time you press and hold the
SOURCE button for a minimum of 1 second, the input source will change as
follows:
Computer1 → Computer2 → Computer3 → Componet → Video → S-Video →
Viewer → Computer1 → ...
If no input signal is present, the input will be skipped. When the input source you
wish to project is displayed, release the button.
NOTE: The COMPUTER 3 connector is available on LT380 only.
OFF
ON
SELECT
POWERPOWER
M
E
N
U
E
N
T
E
R
E
X
I
T
VIDEO
S-VIDEO
VIEWER
LAN
COMPUTER
COMPONENT
3
1
2
Selecting from Source List
Press and quickly release the SOURCE button on the projector cabinet to display
the Source list. Each time the SOURCE button is pressed, the input source will
change as follows: “Computer 1/2/3”, “Component”, “Video” (VCR or laser disc
player), “S-Video”, “Viewer” (slides on a PC card) or “LAN” (LAN port [RJ-45] or
wireless LAN card).
To display the selected source, press the ENTER button.
POWER
AUTO ADJUST
PC CARD
LAMP
STATUS
ON/STAND BY
SOURCE3D REFORM