Tus neeg siv phau ntawv

- 27 -
Adjust vertical system
The VERTICAL functions include 5 menu buttons such as CH1 ～ CH2 (2CH models) and Math, and 8
rotary controls such as VERTICAL POSITION, VOLTS/DIV for each measuring channel.
Settings CH1
～ CH2
Each channel has an independent vertical menu with functions based on that channel.
Switch waveform display on/off (CH & Math function)
Pressing the CH1
～ CH2 or Math buttons has the following effect:
- If the waveform is switched off, it is switched on and the channel menu is displayed.
- If the waveform is already switched on, the channel menu is also displayed.
- If the waveform is already switched on and the channel menu is displayed, switch the waveform and the
channel menu off again with this action
Description of the functions / menu items of the channel menu:
Menu function
Adjustment-
ungen
Description
Coupling
DC
AC
Ground
AC and DC signals are detected
DC components are blocked
Input signal switched off
Inverted
ON
OFF
Waveform is displayed inverted.
Waveform is displayed in the original.
Touch divider
X0,001
to
X1000
Adjust this value to the selected (on the probe)
probe attenuation value in 1-2-5 steps.
Current
measurement
A/V (mA/V)
V/A (mV/A)
Turn the M knob to set the amps / volts ratio. The
range is 100 mA / V - 1 KA / V.
Ampere / Volt ratio = 1 / resistance value
The volt / amp ratio is calculated automatically.
Bandwidth-
limit
Full
20M
Full bandwidth.
Bandwidth limited to 20MHz to reduce interference.