Tus neeg siv phau ntawv

- 11 -
Introduction to user control
Example: 2 channel model
1. Waveform display area
2. RUN/STOP: Can also be used via touch screen
3. Trigger status
4. Activate touch screen function menu
5. Blue line shows cursor position A and B (only with cursor measurement)
6. The [T] mark shows the horizontal trigger position
7. Displays the trigger position in the memory length
8. Shows the current trigger value and the location in the internal memory
9. Lock touch screen operation ( ) / enable ( )
10. Shows the current time (see configuration)
11. WiFi is activated (See Connection to the Android device)
12. Indicates the connection of an external USB device to the oscilloscope
13. Shows battery status (optional)
14. Multimeter window
15. Arrow shows the trigger level position
16. Waveform of CH1
17. The blue line shows the horizontal cursor position (only with cursor measurement)
18. Waveform from CH2
19. Shows the activated measuring function together with the corresponding measured value.
20. Shows the current trigger type
21. Shows the currently active channel for function control in the lower menu
22. Shows the memory depth
23. Shows the frequency of the trigger signal
24. Shows the current sampling rate
25. Shows voltage division, zero position and bandwidth limit, as well as symbol for coupling type
26. Displays the Main Time Base
27. Displays values of the cursor measurement
28. Blue pointer indicates the zero point line of CH2, if not present the channel is not active
29. Yellow pointer indicates the zero point line of CH1, if not present the channel is not active