1
2
ILLUSTRATION OF THE CONTROLS/JACKS ON THE MAIN UNIT 1 2 6 8 10 12 13 4 3 14 5 7 9 11 16 18 20 22 24 15 17 19 21 23 26 27 25 29 31 33 35 28 30 32 1. SPEAKER 2. REMOTE SENSOR 3. POWER INDICATOR 4. FM ST. INDICATOR 5. PREVIOUS SKIP/SEARCH & F.BWD BUTTON 6. NEXT SKIP/SEARCH & F.FWD BUTTON 7. FUNCTION SWITCH 8. PLAY/PAUSE BUTTON 9. STOP BUTTON 10. CD DOOR OPEN/CLOSE AREA 11. HANDLE 12. BAND SWITCH 13. TFT DISPLAY 14. SPEAKER 15. VOLUME CONTROLLER 16. BASS ON/OFF BUTTON 17. PHONES JACK 18.
Note: During DVD play, the TV volume may be at a lower level than during TV broadcasts, etc. If this is the case, adjust the volume to the desired level. If the DVD/CD player is connected to the TV through a video cassette recorder, the picture may not be played back normally with some DVDs. If this is the case, do not connect the player via the VCR.
Note: Inputting leading zero is not necessary. If the chapter/title/track number is behind the cardinal 10, press the unit digit key first and then another unit digit. Some figure inputs may be useless, because it 's greater figure than total title/chapter/track number on the disc. Example: Track 3, press "3" Track 12, press "1" and then "2" Track 21, press "2" and then "1" 3. To start programmed playback, select PLAY on the menu; pressing PROGRAM button again to exit programming. 4.
MP3/MPEG 4 PLAYBACK 1. Load the MP3/MPEG 4 disc onto the disc tray and the TV screen will show all its folders after a few seconds. 2. Select the folder you want by the navigation buttons and then OK button to confirm. 3. The files in this folder are displayed and select your favourable song via navigation buttons and press OK button to start playback. 4. Press NEXT and PREV button to select track directly. 5. Press REPEAT button change play mode.
3.1 AUDIO OUT - Set digital output code format. Options: SPDIF/OFF: If you are not connecting to an amplifier via digital output, please select this option. SPDIF/RAW: Used in general home theatre, select this can output 5.1 channels audio. SPDIF/PCM: Select this it can only output 2 channel, but you will get higher quality audio output. RADIO OPERATION TO PLAY THE RADIO 1. Switch FUNCTION on the main unit to the RADIO position, the POWER Indicator will light up. 2.
DISC HANDLING PRECAUTIONS Hold the disc by the edge so the surface will not be soiled with finger prints. Finger prints, dirt and scratches can cause skipping and distortion. Do not write on the label side with a ball-point pen or other writing utensils. Do not apply benzine, thinner, and liquid that prevents against static electricity. Be careful not to drop or bend the disc. Install only one disc on the disc tray. Do not try to close the disc tray when the disc is not in stalled properly.
