User's Manual

32 |
Operating procedures | RS90 Operating Manual
Skipping busy channels
If one channel is always busy with traffic, you can set the radio to
skip that channel during scanning.
To skip a channel:
• While the channel is displayed during scan, press [OK] to skip over it.
To resume scanning a skipped channel:
• With scanning OFF, as you scroll up and down through channels, the
SKIP icon will be displayed when you are on a skipped channel. With
the SKIP channel selected, press [OK] to cancel the SKIP function.
¼ Notes
• You cannot skip the priority channel.
• The SKIP icon will disappear when the radio is powered OFF/ON.
3CH scan mode
• With any of your favourite channels selected (by pressing the 3CH
key), hold down [SCAN] to start scanning your favourite channels
and the priority channel.
• Press [SCAN] again to stop at the broadcast channel.
• During scanning, press [X] to cancel 3CH scanning and return to the
previously selected channel.
• Press SCAN or PTT to stop at the currently scanned channel.
• To scan only one of your favourite channels, press 3CH then
immediately press and release SCAN.
For further information on 3CH, see “Making a routine radio call” on
page 27.
¼ Note: 3CH scan functionality is limited in some European countries
and, if ATIS is enabled, the 3CH scan mode will be disabled.
Dual watch scan
Dual watch scan monitors the current working channel and the
priority channel.
To enter dual watch scan:
• Short press [SCAN].
The DW icon will be displayed on screen.
Draft v5.0
27 Feb 2014