Instructions / Assembly

ManualsBrandsNatures Composites ManualsComposite Fence PanelsMesa 6 ft. x 6 ft. Raven Black Composite and Steel Privacy Fence Panel

Santa Fe & Mesa Fence 6’ X 6’

Installation Instructions (also for 4’ and 8’ high)

BEFORE YOU BEGIN:

• Verify location of underground utilities before you dig!

• Locate property lines.

• Review local and regional building codes, regulations and zon-

ing laws which may affect your fence.

• Obtain all necessary permits as required by local building codes

Tape Measure

Stakes

String Line

Spray Paint

Post Hole Digger & Shovel

Wheel Barrow

Level

Drill with 3/16” Nut Driver

9/16” End Wrench

9/16” Socket

Miter Saw

Metal Cut-Off Saw

The Santa Fe and Mesa Fence’s versatile, modular design allows for a multitude of configurations suita-

ble for flat, sloping and uneven terrain.

TOOLS REQUIRED:

Step Configuration

Slope Configuration

Variable Height Configuration

Summary of content (6 pages)

PAGE 1
Santa Fe & Mesa Fence 6’ X 6’ Installation Instructions BEFORE YOU BEGIN: Verify location of underground utilities before you dig! • Locate property lines. • Review local and regional building codes, regulations and zoning laws which may affect your fence.
PAGE 2
PARTS LIST Every Santa Fe and Mesa fence kit comes standard with the following components.
PAGE 3
INSTALLATION DOS AND DON’TS Before installation always store fencing materials on a flat surface in a dry location. Don’t allow packaged materials to be rained on, snowed on or exposed to water. Don't use hammer or other tools to install composites fence boards. Do allow for proper air flow under your installed fence. Don’t allow bottom rails, brackets or fence board to set directly on ground.
PAGE 4
POST INSTALLATION  Dig post holes in locations determined earlier. The recommend hole size is shown in figure above; however, installer should consult with local and region building codes for proper post footer design.  Each six-foot panel requires a post at each end. The posts with an adjacent panel must be bolted together before the posts are set in concrete. Mate each adjacent post to each other, making certain to adjust for step, corner, tee and variable height configurations.
PAGE 5
FENCE BOARD INSTALLATION Santa Fe 1. Fence boards come pre-cut to the maximum post spacing size. However, if your installation requires post spacing shorter than 72” (six feet) or your fence board/post gap fails to meet the minimum gap distance you will need to cut the fence boards to the correct length. Measure the distance between the insides of the C-channel of the two post you are installing the section of the fence boards into.
PAGE 6
Groove Mesa Tongue 1” 1. The first Mesa Fence board needs to have a relief cut made to allow for expansion and contraction. To do this, cut only the first board 1” shorter then the distance from the Bottom Rail to the top of the post. 2. Install the first Mesa Fence boards with the groove of the first board inside the post channel and the tongue facing outwards. Press the board into the channel firmly until it stops. 3.