Installation Sheet

INSTALLATION INSTRUCTIONS

1.5” Lift & Turn Drain, DR160

Apply a small bead of

around the underside

of strainer ﬂange (1).

Assemble nut (4),

washer (3) and

gasket (2) (taper side

up) to tailpiece (5).

Thread tailpiece (5)

into strainer ﬂange (1)

and tighten nut (4).

*Note: Rubber

washer is

only used for

glass sinks.

100% Silicone

(non-water based)

W W W .NA TIVETR A ILS. NET

Remove all excess silicone around the drain after the drain has been installed

PAGE 1
INSTALLATION INSTRUCTIONS 1 . 5 ” L i f t & T u rn D rai n , D R 160 1 2 3 4 1. Apply a small bead of 100% Silicone (non-waterbased) around the underside of strainer flange (1). 2. Assemble nut (4), washer (3) and gasket (2) (taper side up) to tailpiece (5). Thread tailpiece (5) into strainer flange (1) and tighten nut (4). * 5 *Note: Rubber washer is only used for glass sinks. Remove all excess silicone around the drain after the drain has been installed W W W . N A T I V E T R A I L S .