Installation Sheet

INSTALLATION INSTRUCTIONS

1.5” Tear Drop Drain, DR150

1. Separate all mounting

hardware as shown.

2. Apply 100% Silicone (non-water

based) to underside of flange

(1) and place directly into

drain opening of the sink.

3. From underneath the

sink slide the Rubber

Gasket (2), the Retaining

Washer (3), and the

Lock Nut (4) onto the

Threaded Seat (1) and

tighten into position.

4. Wrap the threads on

the Tailpipe (5) with

Teflon Tape.

5. Install Tail Pipe (5) into the

bottom of Seat (1)

W W W .NA TIVETR A ILS. NET

Remove all excess silicone around the drain after the drain has been installed