Installation Sheet
1
2
3
4
INSTALLATION INSTRUCTIONS
1.5” Dome Drain, DR120
1. Assemble seals (3) into
the underbody (4)
2.
Apply a small bead of
100% Silicone (non-water based) to the
underside of the waste (2)
3.
Locate the underbody (4)
and seals (3) central to the
underside of the vessel
sink hole
4.
Locate the waste (2)
central to the top side of
the vessel sink hole
5.
Assemble decorative
cover (1) as per diagram,
hand tighten + ¼ turn.
W W W .NA TIVETR A ILS. NET
Remove all excess silicone around the drain after the drain has been installed
*
*
Note: Rubber washer is only
used for glass sinks.
1
2
3
4
INSTALLATION INSTRUCTIONS
1.5” Dome Drain, DR120
1. Assemble seals (3) into
the underbody (4)
2.
Apply a small bead of
100% Silicone (non-water based) to the
underside of the waste (2)
3.
Locate the underbody (4)
and seals (3) central to the
underside of the vessel
sink hole
4.
Locate the waste (2)
central to the top side of
the vessel sink hole
5.
Assemble decorative
cover (1) as per diagram,
hand tighten + ¼ turn.
W W W .NA TIVETR A ILS. NET
Remove all excess silicone around the drain after the drain has been installed
*
*
Note: Rubber washer is only
used for glass sinks.
1
2
3
4
INSTALLATION INSTRUCTIONS
1.5” Dome Drain, DR120
1. Assemble seals (3) into
the underbody (4)
2.
Apply a small bead of
100% Silicone (non-water based) to the
underside of the waste (2)
3.
Locate the underbody (4)
and seals (3) central to the
underside of the vessel
sink hole
4.
Locate the waste (2)
central to the top side of
the vessel sink hole
5.
Assemble decorative
cover (1) as per diagram,
hand tighten + ¼ turn.
W W W .NA TIVETR A ILS. NET
Remove all excess silicone around the drain after the drain has been installed
*
*
Note: Rubber washer is only
used for glass sinks.
1
2
3
4
INSTALLATION INSTRUCTIONS
1.5” Dome Drain, DR120
1. Assemble seals (3) into
the underbody (4)
2.
Apply a small bead of
100% Silicone (non-water based) to the
underside of the waste (2)
3.
Locate the underbody (4)
and seals (3) central to the
underside of the vessel
sink hole
4.
Locate the waste (2)
central to the top side of
the vessel sink hole
5.
Assemble decorative
cover (1) as per diagram,
hand tighten + ¼ turn.
W W W .NA TIVETR A ILS. NET
Remove all excess silicone around the drain after the drain has been installed
*
*
Note: Rubber washer is only
used for glass sinks.