User Manual

InstantWave 11Mbps Wireless Ethernet Client 15
Figure 12. Upgrade Firmware
Use the Browse button to choose the file to be uploaded to the WEC, or type the
file location and name in the File Name field. The Upgrade button will then
become enabled. Click Upgrade. The new firmware will be loaded into the
WEC’s flash memory area. When the firmware upgrade is complete, click Close
to return to the Service card.
Reset WEC Configuration
Click Reset WEC Configuration (Figure 7, page 8) to open the screen shown in
Figure 13, and click Reset to restore the factory default configuration to the WEC.
Figure 13. Reset Configuration
Connect An Ethernet Device
Follow the steps below to connect the WEC to a PC or to another Ethernet device.
step1. Connect one end of the supplied cross-over Ethernet cable to the
port on the rear of the WEC
step2. Connect the other end of the cable to the Ethernet adapter of a PC
or other Ethernet device