Full Product Manual

EN
W415-1542 / D / 11.10.17
16
4.0 FINISHING
POWER SUPPLY SERVICE MUST BE COMPLETED PRIOR TO FINISHING TO AVOID
RECONSTRUCTION.
HEAT VENTS AND AIR OPENINGS CANNOT BE COVERED IN ANY CIRCUMSTANCES.
4.1 FRONT GLASS INSTALLATION
FOR MODELS NEFL72/100FH ONLY:
A. Before installing the front glass, remove the screws securing the paper board on the inside of the
appliance that protects the control panel. Discard the paper board.
B. Reinstall the screws (for recessed installeda appliances only) (FIG. 1).
C. Remove the 2 screws from the top of the appliance.
D. Have 2 people lift the glass up and away from the appliance, holding the glass vertical not flat while
carrying. Place the glass face down onto a soft, non-abrasive surface, careful not to flex the glass.
E. Bend the top tabs flat (FIG. 2).
F. Install the crystal embers. Refer to "CRYSTAL EMBER INSTALLATION" section.
G. Install the front glass by aligning with the pins on the appliance. Press the glass in and down to
securely engage with the brackets. It must be fully engaged to ensure the touch display panel
performs properly.
H. Secure the front glass using the screws provided to the top of the appliance (FIG. 3, next page). If
fully recessed, this step is not necessary.
Please take off the screws, move off the paper board, then fix the screws back.
Paper
For NEFL50FH, NEFL60FH, NEFL72FH, NEFL100FH
Paper
Pin
FIG. 1
FIG. 2
!
WARNING
GLASS MAY BE HOT, DO NOT TOUCH GLASS UNTIL COOLED.
IF EQUIPPED WITH DOOR LATCHES THAT ARE PART OF A SAFETY RELIEF SYSTEM, THEY MUST BE
PROPERLY ENGAGED. DO NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1A
!
WARNING
THE DOOR LATCHES ARE PART OF A SAFETY SYSTEM AND MUST BE PROPERLY ENGAGED. DO
NOT OPERATE THE APPLIANCE WITH LATCHES DISENGAGED.
FACING AND/OR FINISHING MATERIALS MUST NOT INTERFERE WITH AIR FLOW THROUGH AIR
OPENINGS, LOUVRE OPENINGS, OPERATION OF LOUVRES OR DOORS OR ACCESS FOR
SERVICE. OBSERVE ALL CLEARANCES WHEN APPLYING COMBUSTIBLE MATERIALS.
BEFORE DOOR IS REMOVED TURN THE APPLIANCE OFF AND WAIT UNTIL APPLIANCE IS COOL TO
THE TOUCH. DOORS ARE HEAVY AND FRAGILE SO HANDLE WITH CARE.
75.1
THIS WARNING FOR ELECTRICS ONLY:
!
WARNING