Owner`s manual

SETUP MENU
The Setup Menu allows one to customize the operation of the T 775 to the
ancillary equipment used in one’s specic AV system. Unless your system
exactly matches the factory defaults as shown in the accompanying Quick
Start Guide, you will need to use the setup menu to congure the inputs of the
T 775.
At Setup Menu, the following are congurable – Source Setup, Speaker
Setup, Zone Setup, Amplier Setup, Trigger Setup, Listening Mode Setup,
Display Setup and A/V Presets.
To access and navigate through Setup Menu and its sub-menu selections,
please refer to and follow the directions stated in the sections ‘Display the
OSD’ and ‘Navigating the OSD and Making Changes.’
SOURCE SETUP
From Setup Menu, pressing will direct you to the Source Setup menu
wherein you could adjust allocate or change the settings of the following
– Source Setup (Normal View), Source Setup (Table View) and iPod Setup.
SOURCE SETUP (NORMAL VIEW)
The Source Setup (Normal View) menu makes it possible to set, allocate or
change the following settings.
SOURCE
The T 775 is equipped with ten congurable Sources. The settings for each
Source are dependent on the congurations set forth in the parameters for
that particular Source window.
To change or toggle through the Sources, scroll to ‘Source’, press button
and then ENTER or to move up or down the Source selections.
NOTE
 Source5isdefaultedtoiPod.ForSource5tobechangedandallocated
forotherinputs,goto‘iPodSetup’menuunderthe‘SourceSetup’menu.
AtiPodSetupmenu,set‘Enabled’to‘No’–youcannowassignSource5
to other inputs or settings as desired.
ENABLED
One can enable/disable a Source via this option. This is particularly useful
if only few Sources are used and one directly selects the Source from the
front panel, bypassing unused sources.
To enable or disable a particular Source, scroll to ‘Enabled’ and press
keys to select ‘Yes’ or ‘No’.
NAME
A new Name maybe assigned to a Source label. For example, if your DVD
player is attached to ‘Source 1’, it is possible to rename ‘Source 1’ to ‘DVD
Player.’
In order to rename the Source label, scroll to ‘Name’ and press to go the
character. Then, press to pick through the alphanumeric selections.
Press to move to the next character and at the same time save the
changes done on the current character. The name can be as long as twelve
characters.
The new Name will be shown in the VFD as well as on the OSD.
OPERATION
USING THE T 775  SETUP MENU
17
ENGLISHFRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ