Operation Manual

CONDITION POSSIBLE CAUSES POSSIBLE SOLUTIONS

Low or no audio output. • Audio source is powered oﬀ. • Power on audio source.

• Audio volume level is set to minimum. • Set audio to medium volume level.

• No connection between audio source and

• ear pad.

• Ensure full ribbon cable connection between

ear pad and audio source.

• Audio source is muted with Apple control

feature.

• Press center button of Apple control feature to

restore audio.

• Wrong connection of headphone ribbon cable

to ear pad.

• Plug the “L” (left) end of the cable into the

corresponding input at the bottom of “L” (left)

ear pad and “R” (right) end of the cable into the

corresponding input at the bottom of the “R”

(right) ear pad. Connect the other end into the

1/8” (3.5mm) stereo socket on your music player.

Crackling noise or intermittent audio. • Ribbon cable connection is not fully inserted

or pushed home at the audio source or ear pad

end.

• Ensure full cable connection between audio

source and ear pad.

• Connection at the audio source or ear pad end

is damaged.

• Use new ribbon cable.

If you require service, please visit your local authorized NAD service centre, or www.nadelectronics.com/salon for assistance.

TROUBLESHOOTING

SPECIFICATIONS

Rated power 30mW

Frequency response

(20Hz – 20kHz)

± 1.5 dB, -3dB at 15Hz

Sensitivity (1kHz) 100 dB

Total harmonic distortion ≤ 0.25% at 1kHz/mW

Impedance, passive 32 ohms

Transducer, type Dynamic driver

Transducer, size 40 mm

NAD SHALL NOT BE HELD LIABLE FOR ANY TECHNICAL OR USER INTERFACE DISCREPANCIES IN THIS MANUAL. THE NAD HP30 OWNER’S MANUAL MAY BE

SUBJECT TO CHANGE WITHOUT PRIOR NOTICE. CHECK OUT WWW.NADELECTRONICS.COM FOR THE LATEST VERSION OF THE NAD HP30 OWNER’S MANUAL.

ENGLISHPORTUGUÊS FRANÇAISESPAÑOLITALIANODEUTSCHNEDERLANDSSVENSKAРУССКИЙ