User Manual

Mytek Protools-HD DIO Card – User Manual
Signal Routing
While Protools software allows for up to 16 channels of input or
output, only 8 inputs and outputs are active when Mytek 8X192
ADDA is used.
Input
Audio signals transmitted from the 8X192 ADDA converter
originate from the source selected by the switch SOURCE TO
DIGITAL OUT. If ANALOG is selected, 8 analog channels will
show up as inputs in Protools software. If AES/EBU is selected,
8 digital channels will be present as inputs (only 4 if dual wire
AES/EBU mode is used!). Similarly other types of digital inputs
depending on the second DIO CARD2 installed can also be
used. If DIO CARD1 is selected as input, signal output from
Protools will be routed back into Protools inputs. The actual
signal flow in the 8X192ADDA is available in a form of
schematics in the 8X192ADDA manual.
After selecting channel sources in the converter, you can choose
channels selected for recording in the Pro Tools application. In
Setup > I/O Setup you can freely assign track sources to each
interface channels and then assign them to particular tracks.
Setup > I/O Setup
Editing panel – selecting input
interfaces
User Manual ver. 1.1 / oct 2010 www.mytekdigital.com Page: 15 / 29