User`s guide

Operation Instructions VJ-1204
33
AP-77170, Rev. 2.0, 2/04/2007
Step 5 : After the head cleaning, take out the ink cassette from the solvent resistant blister and shake
each cassette gently two or three times before installing.
• The slots for ink cassettes are specified depending on colours of the ink cassettes. Match
the colour marked at the front of the slots with the colour of the ink cassette.
• Install the ink cassette with the arrow mark “
▲” face-up and pointing to the rear of the
printer.
• Insert the cassettes as far as possible. The printer starts filling ink now.
1
2
3 4 5
No. Name
1
Ink cassette
2
Ink cassette slot K
3
Ink cassette slot C
4
Ink cassette slot M
5
Ink cassette slot Y
• “Ink refill **%” is displayed on the operation panel and ink replenishment starts.
• The ink replenishment takes about five minutes. Initial Ink replenishment and pause
operation are repeated during initial filling.
• When “100%” is displayed, the ink replenishment is complete.
Step 3 : After the ink replenishment is completed, the operation panel displays “Media End”.
Notes
After an initial ink fill, the following can occur :
• Printed lines become blurred.
• White lines appear in the prints.
If this is the case, perform a head cleaning, two to three times, as described in the User’s Guide, and
check the results. If the quality of the printed image has not improved, even after performing head
cleaning, then leave the printer unused for more than one hour. After that, perform a head cleaning again
and check the printed image. If the quality still hasn’t improved, then contact your local MUTOH dealer.