User's Manual

19 / 1
Preliminary & Confidential
< Specification may be changed by Murata without notice >
14.2 IC Statements
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
(1) this device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radioexempts
de licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
Under Industry Canada regulations, this radio transmitter may only operate using an antenna of a type
and maximum (or lesser) gain approved for the transmitter by Industry Canada. To reduce potential
radio interference to other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than that necessary for successful communication.
Conformément à la réglementation d'Industrie Canada, le présent émetteur radio peut
fonctionner avec une antenne d'un type et d'un gain maximal (ou inférieur) approuvé pour l'émetteur par
Industrie Canada. Dans le but de réduire les risques de brouillage radioélectrique à l'intention des autres
utilisateurs, il faut choisir le type d'antenne et son gain de sorte que la puissance isotrope rayonnée
équivalente (p.i.r.e.) ne dépasse pas l'intensité nécessaire à l'établissement d'une communication
satisfaisante.
This equipment should be installed and operated with a minimum distance 20cm between the radiator
and your body
Cet équipement doit être installé et utilisé à une distance minimale de 20 cm entre le radiateur et votre
corps
When the Industry Canada certification number is not visible when the module is installed inside another
device, then the outside of the device into which the module is installed must also display a label
referring to the enclosed module. This exterior label can be use wording ”Contains transmitter module
IC: 772C-CMABZ”or “Contains IC: 772C-CMABZ”.
14.3 General Statements
The module is limited to OEM installation ONLY.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or
install module.
Therefore, the final host product must be submitted to [SyChip] for confirmation that the installation for
the module into the host is in compliance with regulations of FCC and IC Canada. Specially, if an
antenna other than the model documented in the Filing is used, a Class 2 Permissive Change must be
filed with the FCC.
Changes or modifications not expressly approved by the manufacturer could void the user’s authority to
operate the equipment.
The LoRa module is for use with external antenna ONLY.
The certified antennas include:
(1) Monopole Antenna with maximum gain 1.04dBi.
(2) PCB antenna with maximum gain of 1.0dBi.
(3) Chip antenna with maximum gain of -2.1dBi.
(4) PCB Antenna + MHF cable with maximum gain of 2dBi.
(5) Chip antenna NN02-224 with maximum gain of 0.9dBi.