User's Manual

PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08) — PAGE 33
PS7060 MULTIQUIP SAW — POINTER ADJUSTMENT
Cold Weather Operation
Glow Plugs
In weather where temperatures reach below 30
o
farenheit/ 0
o
Celsius, Glow Plugs may be required to start engine.
To start engine using assistance of Glow Plugs, turn Ignition
Switch to ON position and monitor Glow Plug Indicator Light on
System Status Indicator, (Figure 26). When Glow Plug Light
goes out, rotate Ignition Switch to the START position. Release
key when engine starts.
In extreme cold weather, optional Block Heaters may be used.
Block Heaters are installed directly onto the crankcase and are
operated by plugging into a 110VAC electrical outlet. Be sure to
use appropriate guage wire when using extension cords and
abide by all safety rules when using electical power, power
cords, and extension cords. Do not use Block Heaters when the
when temperatures are above 20
o
F, (-6.67
o
Celsius).
DO NOT leave optional Block Heaters plugged in for
extended periods when temperatures may rise above
20
o
F, (-6.67
o
Celsius). The oil could "cook" inside the
crankcase and damage to the engine could result.
If the water system is not drained when the saw is not in
use and temperatures fall below 32
o
F, ( 0
o
C), damage
may occur to optional water pumps.
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
Draining the Water System
When low temperatures fall below 32
o
F, ( 0
o
C):
1. If the saw is equipped with an optional Water Pump, open
the drain petcock on the pump and allow the pump to drain.
Turn the water pump switch on for a few seconds to purge
any water remaining inside the pump body.
2. Tilt the saw UP and BACK, to allow water to drain.
3. Tilt the saw FORWARD, to allow water to drain again.
4. If an air compressor is available, blow out the system by
applying compressed air to the Water Inlet.
Block Heaters
Figure 26. Ignition Switch and System Status
Pointer Adjustment
Figure 27. Pointer Assembly
1. Ignition Switch w/key
2. System Status Indicator
3. Glow Plug Light
In cold weather Glow Plugs may stay on up to 3
minutes after engine starts.
2
3
1
1. Lower the front pointer assembly, (Figure 27).