User's Manual

PAGE 22 — PS7060 MULTIQUIP SAW • OPERATION MANUAL — REV. #2 (06/02/08)

PS7060 MULTIQUIP SAW — BASIC ENGINE INFORMATION

Figure 7. Basic Engine Components

Basic Engine Components

The following refer to basic engine components and their functions

that an operator may need to reference . The manufacturer's engine

manual provides further instructions and details of operation and

servicing. The engine shown in Figure 7 is a Deutz BF3L2011

engine.

2. Governor Lever – This lever restricts engine speed (high

idle and low idle) through a speed control device linked to

the accelerator system.

3. Oil Dip Stick – Remove to check amount and condition of

oil in crankcase.

4. Oil Filter – Spin-on type, filters oil for contaminants.

5. Oil Drain Plug & Hose – Remove plug and attach drain

hose to drain crankcase oil.

6. Oil Filler Port – Remove to add fresh crankcase oil.

7. Crankshaft V-Pulley – Check fan V-belt between V-Pulley

and fan to determine proper belt tension.

8. Cooling Fan – Driven by the V-belt, the cooling fan cools

the engine by cooling engine oil that circulates through the

engine block and cylinder head.

9. V-belt Tension Adjustment – This bolt provides means

to adjust the V-belt tension at the alternator bracket.

16. Air Intake Port – Provides air from the air cleaner to the

turbocharger unit.

10. V-belt (Fan belt) – Driven by the engine crank during

operation, drives the fan as well as the aternator.

13. Alternator – Located inside the fan assembly. Provides

current to the electrical system and charges the battery.

Driven by means of a crankshaft/V-belt pulley system.

14. Starter – Starts engine when ignition key is rotated to the

"START" position.

12. Lifting Eye – The lifting eye is provided if the removal/

installation of the engine becomes necessary.

11. Oil Fill Cap – Remove to add engine oil.

1. Fuel Filter – Removes dirt and water from the engine fuel.

15. Flywheel – Main power is taken off from the flywheel end.

17. Turbocharger – Provides pressurized intake air to the

cylinder by means of a turbine energized by exhaust gas

that rotates the blower.

18. Air Cleaner Assembly – Provides clean filtered air to the

air intake port.