Operation Manual

12
13
14
SCAN PLAYBACK
This unit can play back the first five seconds of each recorded message,
which is useful in locating a particular recording.
ERASING A SINGLE MESSAGES
While in the standby mode, select the
desired file folder using the FILE/TIME
button
1
, and the desired message to delete
using the REV
2
or FWD button
3
;
the message number and the message length
will appear in the display.
ERASING ALL MESSAGES IN THE 4 FILE FOLDERS
IMPORTANT NOTES:
.Once message(s)are deleted, they cannot be recovered.
.When the memory is full, Full will appear in the display.
OPERATION
(
CONTINUED
)
SPECIFICATIONS
Recording System……………...................................................Built-in Flash Memory
Recording time…………………………………………………..3369 minutes in LP mode
Speaker………………………………………………………………………….0.2W(8 Ohm)
Output Power…………………………………………………………………………..80mW
Power Source…………………………..3V, “AAA” size×2 batteries(Not Included)
Battery life..........................................Approx 10 hours at recording mode
5 hours at play mode at volume level Max.
Dimensions........................................................................106(H)×36(W)×17(D)mm
Weight....................................................................................50g(without batteries)
Specifications are subject to change without notice.
1
2
While in the standby mode,
select the file folder(A,B,C,D) using the
FILE/TIME button
1
,Press and hold the
PLAY/STOP button
2
for 2 seconds; SCAN
will appear in the display. The unit will
appear in the display. The unit will
automatically scan and play the first five
seconds of each message in the selected
file folder, starting at message one.
The unit will automatically stop after all
Messages have been played. To
playback the message during
scanning, press the change to
playback mode. To stop scan
playback,
Press the PLAY/STOP button twice.
While in the standby mode, press and hold
the ERASE/REPEAT button
1
first, then
press and hold the REC/STOP button
2
for
two seconds; ALL and ERASE will blink in
the display.
To erase all messages, press the
ERASE/REPEAT button again within 5
seconds. If the ERASE button is not pressed
again within the first 5 seconds, the messages
will not erase.
OPERATION
(
CONTINUED
)
1
2
1
2
Press the ERASE/REPEAT button; ERASE will
appear in the display and the first 5 seconds of
the message will play. To erase, press the
ERASE/REPEAT button within the 5 seconds it
is playing and the rest of the messages will be
renumbered. If you do not want to erase, do
not press the ERASE/REPEAT button while it
is playing.