user manual

MVME3100 Installation and Use (V3100A/IH1)
Chapter 1 Hardware Preparation and Installation
2
Overview of Startup Procedures
The following table lists the things you will need to do before you can use this board and tells
where to find the information you need to perform each step. Be sure to read this entire chapter,
including all Caution and Warning notes, before you begin.
Unpacking Guidelines
Unpack the equipment from the shipping carton. Refer to the packing list and verify that all items
are present. Save the packing material for storing and reshipping of equipment.
Note If the shipping carton is damaged upon receipt, request that the carrier’s agent be present
during the unpacking and inspection of the equipment.
!
Caution
Caution
Avoid touching areas of integrated circuitry; static discharge can damage circuits.
Use ESD
Wrist Strap
ESD
Motorola strongly recommends that you use an antistatic wrist strap and a conductive
foam pad when installing or upgrading a system. Electronic components, such as disk
drives, computer boards, and memory modules can be extremely sensitive to
electrostatic discharge (ESD). After removing the component from its protective
wrapper or from the system, place the component flat on a grounded, static-free
surface (and, in the case of a board, component side up). Do not slide the component
over any surface.
If an ESD station is not available, you can avoid damage resulting from ESD by wearing
an antistatic wrist strap (available at electronics stores) that is attached to an active
electrical ground. Note that a system chassis may not be grounded if it is unplugged.
!
Caution
Caution
Inserting or removing modules with power applied may result in damage to module
components.
Table 1-1. Startup Overview
What you need to do... Refer to...
Unpack the hardware. Unpacking Guidelines on page 2
Identify various components on the board. MVME3100 Layout on page 3
Install the MVME3100 board in a chassis. Installing the MVME3100 into a Chassis on page 8
Connect any other equipment you will be using Connection to Peripherals on page 9
Verify the hardware is installed. Completing the Installation on page 10