User's Manual
Table Of Contents
- Declaration of Conformity
- Notes
- Getting Started
- Preparing Your Radio for Use
- Identifying Radio Controls
- Identifying Status Indicators
- Making and Receiving Calls
- Advanced Features
- Scan Lists
- Scan
- Contacts Settings
- Call Indicator Settings
- Call Log Features
- Call Alert Operation
- Emergency Operation
- Dual-Tone Multi Frequency (DTMF)
- Trunking System Controls
- Utilities
- Locking and Unlocking the Keypad
- Turning Keypad Tones On or Off
- Setting the Squelch Level
- Controlling the Display Backlight
- Turning the Radio Tones/Alerts On or Off
- Turning the Talk Permit Tone On or Off
- Turning the LED Indicator On or Off
- Turning the Introduction Screen On or Off
- Accessing General Radio Information
- Batteries and Chargers Warranty
- Limited Warranty
Advanced Features
English
36
Sending an Emergency Call
This feature gives your radio priority access on a channel.
NOTE: The radio operates in the normal dispatch manner
while in Emergency Call, except, if enabled, it returns
to one of the following:
• Tactical/Non-Revert – You talk on the channel you
selected before you entered the emergency state.
• Non-Tactical/Revert – You talk on a programmed
emergency channel. The emergency alarm is sent
on this same channel.
Procedure:
1 Press the programmed Emergency button.
2 The display shows Emergency on the second line. The LED
lights up solid green and the Emergency icon appears on
the Home screen display.
OR
The radio sounds a low-pitched tone, if the selected channel
does not support emergency. Select a channel that shows
Emergency.
3 Hold the radio vertically 1 to 2 inches (2.5 to 5.0 cm) from
your mouth.
4 Press and hold the PTT button. Speak clearly into the
microphone.
5 Release the PTT button to end the transmission and wait for
a response from the dispatcher.
6 Press and hold the programmed Emergency button for
about a second to exit the Emergency Call mode.
If your radio is set to Silent, it will not have any audio or visual
indicators related to the Emergency feature.
Sending an Emergency Alarm
This feature allows you to send an Emergency Alarm, a non-
voice signal, which triggers an alert indication on another radio.
Procedure:
1 Press the programmed Emergency button.
2 The display shows Sending Alarm on the second line. The
LED lights up solid green and the Emergency icon appears
on the Home screen display. An Emergency Enter Tone
sounds upon each retry.