User's Manual
Table Of Contents
- Copyrights
- Contact Us
- Document History
- FCC Information
- About LXN 500
- Overview
- Operation and Configuration
- Getting Started
- Powering On
- Powering Off
- What is Required for Configuration
- Connecting the LXN 500 to a Laptop
- Signing In
- Viewing System Notifications
- Signing Out
- Account Management
- Adding a Single Subscriber (UEs)
- Deactivating/Activating Subscriber
- Importing Subscribers From .csv File
- Deleting Subscriber
- Deleting All Subscribers
- UE Activity
- Statistics
- Setting the eNodeB
- Setting the System
- About LXN 500
- Configuring the DragonForce Server
- Configuring the WAVE 5000 Server
- Provisioning the Mobile Device (UE)
- Vehicle Installation
- Troubleshooting and Maintenance
- Technical Specifications
17
MN003563A01-B
Operation and Configuration
Send Feedback
Operation and Configuration
This chapter describes the initial operation and configuration of the LXN 500 system.
Getting Started
Obtaining the Unit Identification (UID) Number
The Unit Identification (UID) number is required throughout the configuration process of the LXN 500.
The UID can be found on the information label at the bottom side of the LXN 500.
Figure 2-1
LXN 500 Information Label
WARNING! During operation the LXN 500 enclosure surface can become hot. Before using the LXN 500, refer
to the touch hazard warning label located on the upper side of the enclosure.