User's Guide

English
101
2 Place the Source Radio in its SUC. Press and
release the Volume Up button.
You hear "Pass" or "Fail" voice prompt from your
Source Radio.
7 To exit the Clone Mode when the process is
completed, press the Power button, or long press
the PTT button.
13.4
Troubleshooting Cloning Mode
The radio audible voice announces “Bonk” indicating that
the cloning process has failed. In the event that cloning
fails, perform each of the following steps before attempting
to start cloning process again.
1 Ensure that the batteries on both radios are fully
charged and engaged properly on the radio.
2 Check the cloning cable connection on both Single-
Unit Chargers (SUC).
3 Check the cloning cable connection on both Single-
Unit Chargers (SUC and if the cable is switched to
“Cloning”.
4 Ensure that there is no debris in the charging tray
or on the radio contacts and the radio contact is
touching the SUC or MUC contact firmly.
5 Ensure that the Target Radio is turned on.
6 Ensure that the Source Radio is in cloning mode.
7 Ensure that the two radios are both from the same
frequency band, same region and have the same
transmission power.
NOTE:
This cloning cable is designed to operate only
with compatible Motorola Solutions SUCThis
cloning cable is designed to operate only
with compatible Motorola Solutions SUC,
PMLN7140_.
When ordering cloning cable kit, refer to part number
HKKN4028_When ordering cloning cable kit, refer to part
number HKKN4026_. For more information about the
accessories, see AccessoriesFor more information about