User's Manual

63 Section 2A: Making and Answering Calls
Making and Receiving Code Calls In Direct Talk
Mode
To make a code call using Direct Talk:
1. Press and hold the Walkie-Talkie button. DT Transmit
appears on the first line of the display screen. Begin
speaking after your phone emits the Direct Talk tone.
2. Release the Walkie-Talkie button to listen.
The tone emitted from your phone when making a Direct Talk
call is four beeps and sounds different from the standard tone
heard with Walkie-Talkie and Group Walkie-Talkie calls.
If you receive an error message, this means:
䢇 There may be no parties on your channel or code.
䢇 You are out of range.
When you receive a code call using Direct Talk, DT Receive
appears on the first line of the display screen.
Receiving Calls On All Channels
You can set your phone to receive Direct Talk transmissions
from any phone that is in range and set to the same channel,
regardless of the code (1-15), by setting the code to Receive
All. When you receive transmissions with the code set to
Receive All, the display screen changes from Receive All to the
code on which the transmission was received.
Note:
Every other person tuned to same code and channel can hear
your call.
Note:
You cannot initiate a call when the code is set to Receive All. If
you press the Walkie-Talkie button with the code set to
Receive All, you receive an error message.