Installation Guide
Table Of Contents
- MOSCAD-M Remote Terminal Unit
- CONTENTS
- INTRODUCTION
- INSTALLATION
- THE MOSCAD˚M UNIT
- POWER MANAGEMENT
- ETHERNET INTERFACE OPTION
- APPENDIX A: CABLES AND ADAPTERS
- APPENDIX B: MODELS AND ACCESSORIES
- APPENDIX C: CHANGING THE ANALOG INPUT MEASUREMENT TYPE
Appendix C: Changing the Analog Input Measurement Type
47
Remove Main Board
Press the two small tabs (A) at the top of the Main board (shown in Figure 25) to release the
top of the Main board. Then press the two small tabs at the bottom of the Main board (B) to
release the bottom of the Main board. Lift the Main board out of the housing.
Figure 25
Removing Main Board from MOSCAD-M RTU
Remove Expansion Board
Press the two small tabs at the top of the Expansion board (A) to release the top of the
Expansion board. (See Figure 26.) Then press the two small tabs at the bottom of the
Expansion board (B) to release the bottom of the Expansion board. Lift the Expansion board
out of the housing.
Figure 26
Removing Expansion Board from MOSCAD-M RTU