User's Manual

Powering Up the TRAK 9100 Simulcast Site Reference Chapter 5: Installing the Digital Simulcast Remote Site (10Base-2)
Table 5-21 Cabling from the Front Connections on the TRAK 9100 Simulcast Site Reference
From TRAK 9100 Destination Device
Port
Connector
Type
Port
Connector
Type
Description
AC Input A IEC 320
Power Outlet
Power AC Power
AC Input B IEC 320
Power Outlet
Power AC Power
Ethernet IN
RJ45
Port 6 on the
Remote Site L
AN
switch
RJ45
Path for the NTP data
Ethernet IN
RS-232
Port 2 on the
MOSCAD NFM
RS-232
Path for diagnostic information to
MOSCAD
Table 5-22 Cabling from the Rear Connections on the TRAK 9100 Simulcast Site Reference
From TRAK 9100 Destination Device
Port
Connector
Type
Port
Connector
Type
Description
10Base-T 10Base-T
(R
J45)
Re
mote Site
LANSwi Port 5
10Base-T
(R
J45)
NT
P information
RS232 I/O
RS232 MOSCAD NFM2
Port 2
RS232
Diagnostic information routed to
MOSCAD
Reference Output 24-pin D Digital
D
istribution Unit
(DDU) (where
used)
Output to DDU
Powering Up the TRAK 9100 Simulcast Site Reference
The TRAK 9100 has the following three power outputs:
• +5 VDC
• +15 VDC
• -15 VDC
All three outputs have an LED indicator that turns green after the TRAK 9100 powers
up. Figure 5-10 shows the power supply LEDs.
5-30
68P81003Y71-O November 2002