User Manual

Start-up
GE 4500 HSX
GE 7000-7500 HSX
M
26
© MOSA REV.1-09/08
04/06/04 35455-GB
check before each start-up
START-UP FROM "LOCAL/START" FRONT
PANEL
1. Position the LOCAL START / REMOTE
START (I6) selector on LOCAL START;
2. make sure the load plugs are disconnected
or the G.F.I. switch (D) is not inserted
(intervention/insertion lever facing
down), so as to ensure the motor's
start-up without any loads inserted;
3. open the gasoline tap (87) by turning it
towards the inside;
OFF
ON
START
4. turn the start-up key (Q1) to the
ON position;
5. press the CHOKE button (L6) and
simultaneously turn the key to the START
position, holding it until the motor has started;
6. leave the key in the ON position, then wait a
few moments before releasing the choke
button; if the motor tends to shut itself off
press the choke button once again until the
motor has properly started up.
☞
Do not use the CHOKE button if the motor
is hot or if the ambient temperature is
sufficiently high.
REMOTE START
The unit can also be started by means of the
remote TCM 5 control device, or through the
EAS automatic intervention panel.
1. Position the LOCAL START / REMOTE
START (I6) selector on REMOTE START;
2. Connect to the EAS (B3) connector the TCM
5 or the EAS panel.
Start-up with TCM 5
Use the controls located on the TCM 5 in the
same manner as described for start-up from
the front panel.
Start-up with EAS
The EAS panel will automatically manage the
start-up.
See operating manual for EAS panel.
☞☞
☞☞
☞
In case of unsuccessful start-up, do
not insist for longer than 5 seconds.
Wait 10 seconds before attempting
another start-up .
RUNNING-IN
During the first 50 hours of operation, do not use more
than 60% of the maximum output power of the unit and
check the oil level frequently, in any case please stick
to the rules given in the engine use manual.
CAUTION