MSDS

ManualsBrandsMorris Products ManualsAdhesivesAll Weather Cement - Blue, 1-Pint

UNI-WELD PLUMB-TITE BLUE PVC SOLVENT CEMENT

Latest Revision Date...05/05/00

Section 1 IDENTITY OF MATERIAL

TRADE NAME UNI-WELD PLUMB-TITE BLUE PVC SOLVENT CEMENT

PRODUCT NUMBERS 2066S, 2056S, 2046S, 2036S, 2024

FORMULA PVC Resin in Solvent Solution

SYNONYMS PVC Plastic Pipe Cement

SECTION 2 HAZARDOUS INGREDIENTS

INGREDIENTS % CAS NUMBER SEC 313

Amorphous Silica 1-4% 112945-52-5 No

PVC Resin (Non-Hazardous) 10-20% 9002-86-2 No

Tetrahydrofuran (See SECTION-6) 55-65% 109-99-9 No

Methyl Ethyl Ketone 18-30% 78-93-3 Yes

Colorant <1% N/A No

SECTION 3 KNOWN HAZARDS UNDER 29 CFR 1910.1200

HAZARDS YES NO HAZARDS YES NO

Combustible Liquid

X Skin Hazard X

Flammable Liquid X

Eye Hazard X

Pyrophoric Material

X Toxic Agent X

Explosive Material

X Highly Toxic Agent

Unstable Material

X Sensitizer

Summary of content (6 pages)

PAGE 1
UNI-WELD PLUMB-TITE BLUE PVC SOLVENT CEMENT Latest Revision Date...
PAGE 2
Water Reactive Material X Kidney Toxin X Oxidizer X Reproductive Toxin X Organic Peroxide X Blood Toxin Corrosive Material X Nervous System Toxin X Compressed Gas X Lung Toxin X Liver Toxin X Irritant X Carcinogen NTP/IARC/OSHA (see SECTION 6) X X SECTION 4 REGULATION CHEMICAL TLV (TWA) PEL STEL Hazard Action Level Amorphous Silica 10 mg/cu m 20 mppcf N/A N/A Tetrahydrofuran 200 ppm 200 ppm 250 ppm N/A 590 mg/cu m 590 mg/cu m 735 mg/cu m 200 ppm 200 ppm 300 ppm
PAGE 3
EPA HAZARD WASTE CLASS Ignitable Waste/Toxic Waste SECTION 6 EFFECTS OF EXPOSURE ENTRY ROUTE INHALE - YES INGEST - YES SKIN - YES EYE - YES INHALATION May cause irritation of mucous membranes, nose & throat, headache, dizziness, nausea, numbness of the extremities and narcosis in high concentrations. Has caused CNS depression & liver damage in animals, & high concentrations have caused retardation of fetal development in rats.
PAGE 4
NFPA HAZARD SIGNAL HEALTH 2 STABILITY 1 FLAMMABILITY 3 SPECIAL NONE BOILING POINT 151 Degrees F / 66 C MELTING POINT N/A VAPOR PRESSURE 145 mmHg @ 20 Degrees C VAPOR DENSITY (AIR = 1) 2.5 VOLATILE COMPONENTS 80-87% wt. SOLUBILITY IN WATER Negligible PH N/A SPECIFIC GRAVITY 0.92 +/- 0.02 EVAPORATION RATE (BUAC = 1) = 5.5 - 8.
PAGE 5
HAZARDOUS POLYMERIZATION Will Not Occur. CONDITIONS TO AVOID: None INCOMPATIBILITY/ MAT. TO AVOID Acids, oxidizing materials, alkalis, chlorinated inorganics (potassium, calcium and sodium hypochlorite), copper or copper alloys. SPECIAL FIRE FIGHTING PROCEDURE FOR SMALL FIRES: Use dry chemical, CO2, water or foam extinguisher. FOR LARGE FIRES: Evacuate area and call Fire Department immediately.
PAGE 6