Installation Instructions

49-80775-2 7
Care and Cleaning
Professional Vent Hood
Stainless
Steel
Surfaces
(on some
models)
Do not use a steel wool pad; it will scratch
the surface.
To clean the stainless steel surface, use warm
sudsy water or a stainless steel cleaner or
polish. Always wipe the surface in the direction
of the grain. Follow the cleaner instructions for
cleaning the stainless steel surface.
To inquire about purchasing stainless steel
appliance cleaner or polish, or to find the
location of a dealer nearest you, please call
our toll-free number:
Monogram Preferred Service: 800.444.1845
Monogram.com
Light Bulbs
To change the light bulbs:
1. Grasp the outer trim ring and twist until
reaching the unlock position. Then pull the
ring straight out.
2. Grasp the bulb and twist until reaching the
unlock position. Then gently pull the bulb
straight out.
3. Replace with the same wattage, type and
size bulb. Wear gloves. Do not touch bulb
with your bare fingers.
These 120 volt, 50 watt halogen bulbs with a
GU10 base are available at specialty lighting
stores and home building centers.
Order bulb no. WB08X10052.
4. Replace the outer trim ring by inserting the
two retaining tabs into the two tab slots,
pressing the ring flush with the surface of
the hood insert and twisting until reaching
the lock position.
Warming
Lamps
The warming lamps are located on the
underside of the hood.
These 120 volt, 175 watt, par 38 infrared heat
lamp bulbs, with standard base, are available
at some specialty lighting stores.
These infrared bulbs can also be ordered from
your Monogram supplier.
Order bulb no. WB08X10029.
NOTE: If warming lamps are not desired,
additional cooktop lighting can be obtained
by replacing the infrared bulbs with standard
incandescent bulbs with up to 100 watt
maximum ratings, with standard bases. These
bulbs are available at specialty lighting stores.