Installation Guide

MONARCH BAR/PREP SINK INSTALL INSTRUCTIONS
GENERAL GUIDELINES:
1. MONARCH RECOMMENDS USING A PROFESSIONAL INSTALLER TO INSTALL OUR PRODUCTS.
2. YOU CAN USE THE CUTOUT SENT WITH YOUR PRODUCT OR USE A LARGE PIECE OF CRAFT OR TRACING
PAPER FOR USE WHEN MAKING A TEMPLATE. ALL OUR SINKS ARE HANDMADE AND IT IS RECOMMENDED
THAT EACH SINK BE TRACED - USING THE ACTUAL SINK TO MAKE THE TEMPLATE FOR THE CUTOUT.
3. FLIP SINK UPSIDE DOWN AND TRACE OUTSIDE EDGE ONTO CRAFT OR TRACING PAPER. ADD A SECOND
LINE INSIDE THE FIRST LINE THAT EQUALS THE WIDTH OF THE RIM. CUT OUT THE CENTER OF THE
TEMPLATE USING THE SECOND LINE.
4. PLACE THE CUTOUT TEMPLATE ON THE COUNTERTOP AND TRACE THE TEMPLATE. CUT THE INSTALLATION
HOLE IN THE COUNTERTOP.
5. POSITION THE SINK IN THE HOLE AND CHECK FOR GAPS AROUND THE RIM. ELIMINATE GAPS BY GENTLY
TAPPING THE RIM WITH A RUBBER MALLET. ‘
6. WEIGH THE SINK DOWN AND APPLY POLYUERETHANE EXPANDING FOAM UNDERNEATH THE SINK TO SEAL
THE GAP BETWEEN THE SINK AND THE COUNTERTOP TO SECURE THE SINK IN PLACE. AGAIN, BE SURE TO
WEIGH THE SINK DOWN WHILE THE SILICONE / POLYUERETHANE FOAM DRIES.
7. USE PLUMMERS PUTTY ON THE UNDERSIDE OF THE DRAIN LIP TO SEAL THE DRAIN TO THE SINK.