Operation Manual

User Manual
18
Picture 5-32
5.2.6.6 Set Serial
Picture 5-33
5.2.7 System
Picture 5-34
5.2.7.1 Time Set
Picture 5-35
5.2.7.2 Password
Picture 5-36
The [System] Menu includes the below sub-menus: Time Set,
User Password, Audio/Video Setting, Language select, System Info
and System Maintain.
After entering into the [System] menu, you can freely configure
the system parameters to meet your needs.
This option allows you set the device ID for the DVR and
set the system password if you want to use one. The new
passwords will be available after clicking [APPLY] button.
When you set Password Enabled to “ON” firstly (shown as
Picture 5-37), you can setup a user password and
administrator password respectively. The password is consist
of digital number 0~9 and supports up to 6 characters.
The channel is separated into a 13X10 area. When any object
moves into the motion detection area, and the area where the object is
located is displayed in red recording will be triggered. In the
semi-transparent area the motion detection is off.
On the [System] menu screen, click [Time] icon to enter into [Time
set] menu shown as Picture 5-35.
Now you are allowed to modify system date, time, date/time
format and time zone, setup DST (day saving time) status and
mode.
When Multiple DVRs are controlled by keyboard, user needs to set
communication protocol.
 Baud rate: set baud rate of serial protocol
 Data Bit: Set data bit.
 Stop Bit: Set stop bit
 Check: allow you set [Check] to none.