Use and Care Manual

ManualsBrandsMold Armor ManualsCleaning2.5 gal. Rapid Clean Remediation Mold Remover

Kills Mold.

Visible Results in 1 Minute.

No Scrubbing Required

For Use On Hard Non-porous Surfaces

Proven one-step disinfectant, cleaner, sanitizer,

fungicide, mildewstat

, and virucide

†

Kills,

Cleans,

& PREVENTS

mold & mildew

KEEP OUT OF REACH OF CHILDREN

WARNING

SEE BACK PANEL FOR

ADDITIONAL PRECAUTIONARY STATEMENTS.

KEEP OUT OF REACH OF CHILDREN

WARNING

SEE BACK PANEL FOR

ADDITIONAL PRECAUTIONARY STATEMENTS.

ACTIVE INGREDIENTS:

Sodium hypochlorite.......... 4.0%

Sodium carbonate............. 1.0%

OTHER INGREDIENTS: .... 95.0%

TOTAL : ........................ 100.0%

PHYSICAL AND CHEMICAL HAZARDS: This product contains an oxidizing agent. Do not use

or mix with other chemicals such as toilet bowl cleaners, rust removers, or any cleaners

containing acids or ammonia as hazardous gases may be released. Prolonged contact with

metal may cause pitting or discoloration.

ENVIRONMENTAL HAZARDS: This product is toxic to fish and aquatic organisms.

DIRECTIONS FOR USE: It is a violation of Federal Law to use this product in a manner

inconsistent with its labeling.

For surfaces that may contact food, a potable water rinse is required. Do not use on eating/

cooking utensils, glasses/dishes or cookware. Contact with clothing, carpet, fabric, painted

wood surfaces or paper may cause discoloration or damage. Test on a small inconspicuous

area before applying to surface. Safe for use on hard non-porous surfaces.

USE ONLY IN WELL VENTILATED AREAS: Vapors may irritate. Before use, open windows

and turn on fan. If the vapors bother you, leave the room while the product is working.

TO USE: Pour product into a pump-up sprayer. Do not dilute. Replace trigger or follow

manufacturer’s instructions for use of pump-up sprayer.

TO SANITIZE: For use on hard, non-porous, non-food contact surfaces. Pre-clean heavily

soiled surfaces. Spray surface until thoroughly wet. Let stand 10 seconds. Wipe clean with

a damp cloth. Kills 99.9% of Enterobacter aerogenes and Staphylococcus aureus.

TO DISINFECT bacteria, viruses

†

, and fungi on hard, non-porous surfaces: Pre-clean

heavily soiled surfaces. Spray surface until thoroughly wet. Let stand 30 seconds. To kill

mold and mildew, let stand 60 seconds. Then rinse with water or wipe with a damp cloth.

Kills 99.9% of Pseudomonas aeruginosa, Salmonella enterica, Staphylococcus aureus,

Trichophyton mentagrophytes, Aspergillus niger (60 seconds), Influenza A H1N1

†

Respiratory Syncytial Virus

†

, Human Coronavirus

†

FG592 / J8784

EPA Registration No. 4091-23

EPA Establishment No. 55852-IL-001

PRECAUTIONARY STATEMENTS: Hazards to Humans and Domestic Animals

WARNING: Causes moderate eye irritation. Do not get on skin or on clothing. Avoid contact with eyes.

Wear waterproof gloves and appropriate clothing. Wash thoroughly with soap and water after handling

and before eating, drinking, chewing gum, using tobacco or using the toilet. Remove and wash

contaminated clothing before reuse.

Non-Abrasive Formula · Works Indoors & Outdoors · Contains No Phosphates

Safe for use on: Acrylic, Sealed Fiberglass, Laminate, Steel, Glazed Porcelain, Glass,

Sealed Grout, Stainless Steel, Chrome, Glazed Ceramic, Mirrors, Formica

, Corian

Sealed Granite, Plastic Laminate, Linoleum, Crystal, and Vinyl.

TO PREVENT MOLD AND MILDEW GROWTH ON HARD SURFACES: To inhibit mold and

mildew growth: Thoroughly wet surface. Allow to air dry. Repeat every 7 days to inhibit mold

and mildew growth. Effective against Aspergillus niger*. Pre-clean heavily soiled surfaces.

TO CLEAN AND REMOVE MOLD AND MILDEW STAINS: Apply to stains. No scrubbing

required. Wait 10 minutes for stains to disappear, then rinse with water or wipe with a damp

sponge. Rinse vinyl or rubber surfaces within 15 minutes as prolonged contact may cause

damage.

TO TREAT WATER DAMAGE CAUSED BY SEWER BACKUP, RIVER FLOODING, LEAKY PIPES,

WINDOWS, ROOFS (NOT FOR USE IN CALIFORNIA): Extract excess water and remove gross

filth or heavy soil along with non-salvageable materials. Test hidden area for colorfastness.

Saturate affected material with undiluted product using a sprayer with a coarse spray tip.

Allow the materials to remain damp for at least 1 minute prior to extraction.

STORAGE AND DISPOSAL

Store in original container in areas inaccessible to children. Keep securely closed. Nonrefillable

container. Do not reuse or refill this container. Place container in trash or offer for recycling.

FIRST AID:

IF IN EYES: Hold eye open and rinse slowly and gently with water for 15-20 minutes. Remove

contact lenses, if present, after the first 5 minutes, then continue rinsing eye.

IF ON SKIN OR CLOTHING: Take off contaminated clothing. Rinse skin immediately with plenty of

water for 15-20 minutes.

Call a poison control center or doctor for treatment advice. Have the product container or label

with you when calling a poison control center or doctor, or going for treatment. National Poison

Control Center: 1-800-222-1222.

MOLD ARMOR RAPID CLEAN REMEDIATION

PEEL

HERE

NET CONTENTS: 2.5 GAL (9.46 L)

QUESTIONS? COMMENTS?

CALL 888-326-7743

Distributed by: W.M. Barr & Co., Inc.

6750 Lenox Center Court

Suite 200, Memphis, TN 38115

J8783

7.125"

6.000"

TOP PLY

ADHESIVE SIDE

PANEL 2

BACK OF PANEL 1

BOTTOM PLY

FACER SIDE

PANEL 3

HINGE AREA - NO TEXT

TXET ON - AERA EGNIH

7.1250"

5.8750"

0.3750"

6.7500"