SDS

09/11/2015Revision:
09/14/2015Printed:
Page: 1
Mold Armor Pro Aerosol
SAFETY DATA SHEET
Mold Armor Pro Aerosol
Product Name:
Company Name:
Cleaner
Intended Use:
FG553
Product Code:
1. PRODUCT AND COMPANY IDENTIFICATION
This chemical is a pesticide product registered by the United States Environmental
Protection Agency and is subject to certain labeling requirements under federal pesticide
law. These requirements differ from the classification criteria and hazard information
required for safety data sheets (SDS), and for workplace labels of non-pesticide
chemicals. The hazard information required on the pesticide label is reproduced below.
The pesticide label also includes other important information, including directions for use.
Additional Information
W. M. Barr
Company Name:
2105 Channel Avenue
Memphis, TN 38113
3E 24 Hour Emergency Contact
Emergency Contact:
[phone]
W.M. Barr Customer Service
Information:
[phone]
[phone]
Phone Number:
www.wmbarr.com
Web site address:
Supplier Name and Address:
Manufacturer Information:
2. HAZARDS IDENTIFICATION
P210 - Keep away from heat/sparks/open flames/hot surfaces. - No smoking.
P211 - Do not spray on an open flame or any other ignition source.
P251 - Pressurized container: Do not pierce or burn, even after use.
GHS Precaution Phrases:
P308+313 - IF exposed or concerned: Get medical attention/advice.
GHS Response Phrases:
P410+412 - Protect from sunlight and do not expose to temperatures exceeding 50
ºC/122 ºF.
GHS Storage and Disposal
Phrases:
H222 - Extremely flammable aerosol.
H280 - Containers gas under pressure; may explode if heated.
GHS Hazard Phrases:
Flammable Aerosols, Category 1
Danger
GHS Signal Word:
Hazard Rating System:
Instability
Special Hazard
Health
Flammability
HEALTH
FLAMMABILITY
PPE
PHYSICAL
1
0
4
X
1
4
NFPA:HMIS:
May cause slight eye irritation.
Potential Health Effects
(Acute and Chronic):
Licensed to W.M. Barr and Company: MIRS MSDS, (c) A V Systems, Inc.
GHS format