Specification

Banbury
®
Technical Specication
18" & 24" Towel Bars Y2618 & Y2624
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
Y2618BN – 18" Towel Bar
Brushed Nickel Finish
Y2624BN – 24" Towel Bar
Brushed Nickel Finish
Y2618BRB – 18" Towel Bar
Mediterranean Bronze Finish
Y2624BRB – 24" Towel Bar
Mediterranean Bronze Finish
Y2618CH – 18" Towel Bar
Chrome Finish
Y2624CH – 24" Towel Bar
Chrome Finish
Y2618BL – 18" Towel Bar
Matte Black Finish
Y2624BL – 24" Towel Bar
Matte Black Finish
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Towel Bar post is die cast from highest quality
zinc alloy (Zamac). Casting is
plated Chrome, Brushed Nickel, Matte Black or
Mediterranean Bronze. Towel Bar is
aluminum for Brushed Nickel, Matte Black and
Chrome nishes and stainless steel for Medi-
terranean Bronze.
Stock Number: Y2618, 18 in. Towel Bar
Y2624, 24 in. Towel Bar
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2021 Moen Incorporated. Moen is a registered trademark and Banbury is a trademark of Moen
Incorporated. All rights reserved.
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting plate location that corresponds to
your product.
4. We recommend using the horizontal holes for drywall installation.
5. Remove the template from the wall.
6. Fold ends of the plastic toggle together and insert into each hole in the wall.
7. Lightly tap anchors until ush with the wall.
8. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor.
9. Remove pin and repeat on all anchors.
10. One at a time, place each mounting plate over anchors (notch facing
downward) and insert screws through plate into anchors.
11. Tighten screws.
12. Position each end post with setscrews facing down and place over
both mounting plates. Tighten the setscrews.
3.100
(78.75)
2.016
(51.21)
18" Towel Bar: 18.000
(457.20)
24" Towel Bar: 24.000
(609.60)