Replacement Part List

Banbury
®
Technical Specication
Pivoting Paper Holder Y2608
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
Y2608BN – Pivoting Paper Holder
Brushed Nickel Finish
Y2608BRB – Pivoting Paper Holder
Mediterranean Bronze Finish
Y2608CH – Pivoting Paper Holder
Chrome Finish
Y2608BL – Pivoting Paper Holder
Matte Black Finish
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting plate location that corresponds to
your product.
4. We recommend using the horizontal holes for drywall installation.
5. Remove the template from the wall.
6. Fold ends of the plastic toggle together and insert into each hole in the wall.
7. Lightly tap anchors until ush with the wall.
8. One at a time, insert plastic pin into each of the anchors and lightly tap to
activate anchor.
9. Remove pin and repeat on all anchors.
10. One at a time, place each mounting plate over anchors (notch facing
downward) and insert screws through plate into anchors.
11. Tighten screws.
12. Position each end post with setscrews facing down and place over
both mounting plates. Tighten the setscrews.
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Pivoting Paper Holder post is die cast from
highest quality zinc alloy (Zamac). Casting
is plated Chrome, Brushed Nickel, Matte
Black or Mediterranean Bronze. The
Pivoting Paper Holder arm is stainless steel.
Stock Number: Y2608 Pivoting Paper Holder
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2021 Moen Incorporated. Moen is a registered trademark and Banbury is a trademark of Moen
Incorporated. All rights reserved.
2.008
(51.00)
3.100
(78.75)
9.567
(243.00)