Installation Guide

 Y2686BN – Towel Ring
Brushed Nickel Finish
 Y2686BRB – Towel Ring
Mediterranean Bronze
Finish
 Y2686CH – Towel Ring
Chrome Finish
 Y2686BL – Towel Ring
Matte Black Finish
25300 AL MOEN D R I VE  N OR TH OLMSTED , OH 44070
C OR POR ATE H EAD QU AR TER S: (800) 321 -8809  FAX: [phone]
I N TER N ATI ON AL: (440) 962 -2000  F AX: [phone]
C U STOMER SER VI C E (U SA): 800 -882-0116  F AX: [phone]
W W W . MOEN . C OM
Copyright Moen Incorporated
Towel Ring post is die cast from
highest quality zinc alloy (Zamac).
Casting is plated in Chrome,
Brushed Nickel, Matte Black or
Mediterranean Bronze.
Towel ring is aluminum for Brushed
Nickel, Matte Black and Chrome
finishes and stainless steel for
Mediterranean Bronze.
Cleaning Instructions:
1. Remove mounting plate from hardware pack.
2. Position the mounting plate on the wall at desired location with
“UP” facing you. Mark hole locations.
3. Drill two holes as marked using a 5/16” drill bit.
4. Fold ends of the plastic toggle together and insert into each hole
in the wall.
5. Lightly tap anchors until flush with the wall.
6. One at a time, insert plastic pin into each anchor and lightly tap to
activate anchor.
7. Place the mounting plate on the wall over the installed wall
anchors with “UP” facing you.
8. Tighten screws.
9. Place decorative product over the mounting plate with setscrew
facing down and tighten setscrew.
Stock Number:______________________ Towel Ring
By Moen Inc.
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Y2686
Banbury
®
Technical Specification
Towel Ring
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.