Use and Care Guide

Lindor™ Technical Specication
Pivoting Paper Holder MY8708
Stock Numbers: Dimensions:
Installation Instructions:
Cleaning Instructions:
MY8708CH – Paper Holder
Chrome
MY8708BN – Paper Holder
Brushed Nickel
MY8708BL – Paper Holder
Matte Black
1. Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove both mounting posts by loosening each set screw.
3. Place each mounting posts on the template. The notch should be facing
downward. To ensure correct alignment, it is very important that the
mounting post is installed straight.
4. One at a time, place each anchor screw through the mounting post, centered
in each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self-drill and tap into drywall. Only insert screw
½ to ¾ of the way into the wall.
5. After all screws are installed, tear the template away from the wall.
6. Tighten all four screws. Do not over tighten.
7. Place the square back plate over each mounting post.
8. Place each post over the mounting post (set screw down). Pivoting post with
bar should be on the left side. Tighten both set screws
To preserve the ne nish of this product, clean only with a soft damp cloth.
Dry well. Do not use commercial or abrasive cleaners.
Materials:
Pivoting Paper Holder is constructed of
zinc.
Stock Number: ____________ Pivoting Paper Holder
By Moen Incorporated
25300 AL MOEN DRIVE • NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: [phone] • FAX: [phone]
INTERNATIONAL: (440 ) 962-2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.MOEN.COM
©
2020 Moen Incorporated. Moen is a registered trademark and Lindor is a trademark of
Moen Incorporated. All rights reserved.
3-1/4"
83 mm
2"
52 mm
2"
51 mm
7-5/16"
186 mm