Installation & Assembly

Quick Connect Fittings

Installation and Removal

Tool needed: Pliers (optional)

Identify your connection style and move to the appropriate step.

Below are the different hoses and quick connect fittings addressed by this document. The two

hose styles are found on both Hydrolockl and Duralock connection systems. These are only

included for reference.

Hose Ends

White Tip Brass Tip

A. Hydrolock Fittings

Hose Under Faucet Double Female Small Double

Female

Go to step 1 to remove or step 4 to install

B. Duralock Fitting

Go to step 10 to

remove or step

12 to install

Disconnecting a Hydrolock Fitting

2. Find the two white plastic tabs at the end of the Quick Connect fitting. Squeeze these tabs

together with your fingers or pliers. As you squeeze these tabs they will become pushed into

the black plastic housing. This will cause the white button on the opposite side of to pop out a

little.

3. The Quick Connect fitting is now unlocked. Slide the fitting off.

PAGE 1
Quick Connect Fittings Installation and Removal Tool needed: Pliers (optional) Identify your connection style and move to the appropriate step. Below are the different hoses and quick connect fittings addressed by this document. The two hose styles are found on both Hydrolockl and Duralock connection systems. These are only included for reference. Hose Ends White Tip Brass Tip A. Hydrolock Fittings Hose Under Faucet Double Female Female B.
PAGE 2
Connecting a Hydrolock Fitting 4. Inspect the Quick Connect fitting to insure the white button is pulled out and slightly raised from the black plastic. 5. Slide the Quick Connect onto the shaft until the Quick Connect is fully seated and can not be pushed any further. Make certain the hose is pushed into the Quick Connect straight and not at an angle. 6. Push the white button until you hear a click. 7.
PAGE 3
Disconnecting a Duralock Fitting 10. 11. Push the hose gently into the Duralock connector and then push the black button. While holding this black button pull the hose end out of the Duralock fitting. Connecting a Duralock Fitting 12. Hold the Duralock fitting without pushing the button. Slide the hose end into the this fitting until you hear the fitting “click”. This indicates the lock has engaged. If you are unable to get this fitting to lock, see the special note at the end of this section 13.