How to Guide

1.
Position the mounting template on the wall in the desired location. Using a
level, align the template and tape it to the wall.
2. Remove both mounting posts by loosening each set screw.
3. Place each mounting post on the template. The notch should be facing
downward.
4. One at a time, place each anchor screw through the mounting post, centered in
each large hole. Using a Phillips screwdriver, turn the anchor screw while
applying pressure. Screw will self-drill and tap into drywall. Only insert
screw ½ to ¾ of the way into the wall.
5. After all screws are installed, tear the template away from the wall.
6. Tighten all four screws. Do not over tighten.
7. Assemble the towel bar and posts.
8. While assembled, position each end post with the set screw down and place
over both mounting posts. Tighten the set screw at the bottom of each base.
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International 2006 Literature #BA1216
Towel bar
posts are constructed of
zinc. Bar is constructed of aluminum.
q
DN1
6
18
B
N
–
18” Towel Bar
Brushed Nickel Finish
q DN1624BN – 24” Towel Bar
Brushed Nickel Finish
Cleaning Instructions:
Stock Number:
___________
___________Towel Bar
By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
18” & 24” Towel Bar
DN1
6
18 & DN1
6
24
Blakeley™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.