Specification Sheet

q
YB
8
2
01
AZ
–
Tank Lever
Antique Bronze Finish
q YB8201BN – Tank Lever
Brushed Nickel Finish
q YB8201CH – Tank Lever
Chrome Finish
q YB8201ORB – Tank Lever
Oil Rubbed Bronze Finish
25300 AL MOEN DRIVE
•
NORTH OLMSTED, OH 44070
CORPORATE HEADQUARTERS: (800) 321- 8809 • FAX: [phone]
INTERNATIONAL: (440) 962- 2000 • FAX: [phone]
CUSTOMER SERVICE (USA): 800-882-0116 • FAX: [phone]
WWW.CSI.MOEN.COM
Copyright Creative Specialties International Literature #BA1433
1. Remove existing tank lever.
2. Remove the arm mechanism from
the new tank lever by loosening
screw A.
3. Position the new tank lever through
the flush tank hole.
4. The tank lever handle should be
pointing away from the toilet bowl.
5. Install the nut inside the tank and
tighten. Depending on the curvature
of the tank, there might be a slight
gap between the outside of the tank
and the base of the lever.
6. Loosen, but do not remove screw B
on the arm mechanism.
7. Replace the entire arm mechanism
onto the tank lever.
8. Tighten screw A.
9. Adjust the arm mechanism so it does
not come in contact with the tank wall
or any part of the flush mechanism
parts inside the tank.
10. Tighten the adjustment screw (screw
B) on the arm mechanism.
11. Attach the flapper valve chain to one
of the three holes provided on the
arm.
12. Make sure that the arm does not
activate, and no water is leaking thru
the flapper valve when the handle is
in its normal position, (not flushing).
Cleaning Instructions:
Tank Lever
is
constructed of zinc.
The arm mechanism is constructed
of plastic.
Stock Number:
______________________
Tank Lever
By Creative Specialties
Installation
Instructions:
Materials
:
Stock Numbers:
Dimensions:
Tank Lever
YB8201
Rothbury™ Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.