Specification

 Y2608BN – Pivoting Paper
Holder
Brushed Nickel Finish
 Y2608BRB – Pivoting Paper
Holder
Mediterranean Bronze Finish
 Y2608CH – Pivoting Paper
Holder
Chrome Finish
25300 AL MOEN D R I VE  NOR TH OLMSTED, OH 44070
C ORPOR ATE H EADQU AR TERS: [phone]  FAX: [phone]
I NTER N ATI ONAL: (440) 962 -2000  F AX: (440) 962 -2726
C USTOMER SERVI C E (USA): 800 -882-0116  F AX: [phone]
W WW. MOEN .C OM
Copyright Creative Specialties International Literature # BA1441
Pivoting Paper Holder post is die
cast from highest quality zinc alloy
(Zamac). Casting is plated Chrome,
Brushed Nickel or Mediterranean
Bronze. The Pivoting Paper Holder
arm is stainless steel.
Cleaning Instructions:
1. Position the mounting template on the wall in the desired location.
2. Using a level, align the template and tape it to the wall.
3. Drill two 5/16” holes at each mounting plate location that
corresponds to your product.
4. We recommend using the horizontal holes for drywall installation.
5. Remove the template from the wall.
6. Fold ends of the plastic toggle together and insert into each hole
in the wall.
7. Lightly tap anchors until flush with the wall.
8. One at a time, insert plastic pin into each of the anchors and
lightly tap to activate anchor.
9. Remove pin and repeat on all anchors.
10. One at a time, place each mounting plate over anchors (notch
facing downward) and insert screws through plate into anchors.
11. Tighten screws.
12. Position each end post with setscrews facing down and place over
both mounting plates. Tighten the setscrews.
Stock Number:______________________Pivoting
Paper Holder By Creative Specialties
Materials:
Installation Instructions:
Stock Numbers:
Dimensions:
Pivoting Paper Holder
Y2608
Banbury® Technical Specification
To preserve the fine finish of this product, clean only with a soft
damp cloth. Dry well. Do not use commercial or abrasive cleaners.