REF /REF : 99812 Roost Inducts SUPERMODEL: PCT-2014 CERAMIC PTC HEATER Instruction Manual ONE-YEAR Intertwine LIMITED WARRANTY 4006090 Trademark Industries Customer Service EST, Monday fo Friday 1-855-565-5575 IMPORTANT: READ THIS OPERATOR’S MANUAL BEFORE USING! MADE IN CHINA
LA WARNING IMPORTANT INSTRUCTIONS When using electrical appliances, basic precautions should always to be followed to reduce the risk of fire, electric shock, and injury to persons, including the following: 1. Read all instructions before using this heater. 2. This heater is hot when in use. To avoid bums, do not let bare skin touch hot surfaces. If provided, use handles when moving this heater.
17. WARNING: In order to avoid overheating, do not cover the heater. 18. The appliance must never be placed immediately beneath a wall socket, as the heat it generates could damage the electrical installation. 19. CAUTION RISK OF ELECTRIC SHOCK. DO NOT OPEN NO SERVICEABLE PARTS INSIDE. INTENDED PURPOSE This appliance is intended only for the heating of indoor living spaces and only for domestic use.
PROTECTION AGAINST THE DANGER OF FIRE 1. Warning! As the appliance works at high temperatures, please observe the following safety information to prevent fire 2. While the appliance is operating, there must be no flammable objects (e.g. curtains, paper} in the immediate vicinity of the appliance. 3. Never use the appliance to dry textiles or other items on, over or in front of the appliance. 4. When setting up the appliance, maintain a minimum distance of 0.9m from other appliances and the wall. 5.
PARTS DESCRIPTION (D Camry handier @ Operating switch () Power Led light @ Temperature regulator SPECIAL FEATURES » Overheat Shut-Off Protection Stern: This heater includes a protection system that shuts off the heater if it overheats for any reason. « Inlet Alr Overheat Protection System: This heater will automatically shut off if the inlet air duct gets abstracted and causes the unit fo overheat. » Safety Tip-Over Switch: This heater is designed to automatically shut-off when tipped to all direction.
OPERATING INSTRUCTIONS 1. Plug the power supply cord into a grounded wall outset. (120VAC, 60Hz). Important: This heater comes with a grounded (3 prong) plug. The grounded plug must be used with a grounded outlet. Do not use an adapter in a 2-slot wall outset unless the ground plug of the adapter property connects to a building ground. Using heater without properly grounded outlet or adapter could result in an electric shock hazard. The cord has a plug as shown at A in Figure below.
MAINTENANCE 1. Ways tum OFF the heater and disconnect the cord from the electrical outset before cleaning your heater. 2. Light accumulated dust may be removed from the heater with a soft cloth or vacuum cleaner. 3. Wipe the exterior surfaces of the heater occasionally with a damp cloth (not dripping wet), using a solution of mild detergent and water. Dry the case thoroughly before operating the heater.
AVERTISSEMENT INSTRUCTIONS IMPORTANTES Lors de I'utilisation d'appareils électriques, des précautions de base devraient toujours être prises afin de réduire le risque d'incendie, de décharge électrique et de blessures; elles comprennent notamment les &cléments suivants : 1. Lire toutes les instructions avant d'utiliser ce chauffage. 2. Ce chauffage est chaud lorsqu'il fonctionne. Pour éviter les surliures, ne pas laisser des parties de peau nue entrer en contact avec les surfaces chaudes.
13. Utiliser ce chauffage conformément aux instructions de ce manuel. Tout autre usage non recommandé par le fabricant peut causer un incendie, une décharge électrique ou des blessures. 14, Éviter d'utiliser une rallonge électrique, car celle-ci risque de surchauffer et de causer un incendie. Toutefois, 'il est nécessaire d'en utiliser une, elle doit &tre de calibre 16 AWG minimum et pouvoir supporter au moins 2 000 Watts. 15.
8. Ne jamais insérer les doigts ou d'autres objets par les grilles de protection vers l’intérieur de I'appareil. 9. Ne jamais toucher I'appareil, le cordon ou la prise de secteur avec des mains humides. 10. Toujours tirer le cordon d'alimentation par a prise. Ne jamais tirer sur le cordon directement 11. Vérifier que le cible d'alimentation n'est pas déformée, vrillé ou abîme. 12. Vérifier que le c Able d'alimentation n'est pas endommagé sur des bords tranchants. 13.
* Ne pas placer 'appareil dans un environnement chaud, mouillé ou trais humide ni & proximité de matières inflammables. * La prise de secteur murale doit être facilement accessible pour que le cordon d'alimentation puisse &tre rapidement débranché en cas d’urgence.
INSTRUCTIONS D’UTILISATION 1. Brancher le cordon d'alimentation dans une prise électrique murale de mise a la terre. 120V ca, 60 Hz). Important: Ce chauffage dispose d'une prise de mise A Ia terre (3 fiches). La prise de mise & la terme doit être utilisée avec une prise murale de mise a la terre. Ne pas utiliser un adaptateur dans une prise murale & deux fiches, sauf si la prise de mise 4 a tee de 'adaptateur est bien branchée & une mise a la terre du bâtiment.
ENTRETIEN 1. Avant de nettoyer le chauffage, toujours I'éteindre et débrancher le cordon d'alimentation de la prise électrique. 2. Une faible couche de poussière pot &tre retinsse du chauffage avec un chiffon doux ou un aspirateur. 3. Nettoyer les surfaces extérieures du chauffage de temps en temps avec un chiffon humide (il ne doit pas être trop imbibé) en utilisant une solution de détergent doux et d'eau. Sécher la grille minutieusement avant de faire fonctionner le chauffage.