Measurement Guide

ManualsBrandsModern Homes ManualsRoller ShadesLight Filtering White 27 in. x 72 in. Cordless Sheer Shade

INSTRUCTION FOR UNIVERSAL DRIVE TENSION DEVICE

WARNING : It is imperative that the drive tension device for bead chain/cord loop be properly secured to the

wall or window frame to reduce a child’s access to the bead chain/cord loop. Young children can wrap bead

chain/cord loops around their necks and strangle. Always keep loops secured and out of the reach of children.

Note to Manufacturer or Fabricator: The shade will not operate properly unless the drive tension device is

secured to comply with ANSI/WCMA standard section 6.5.2.

Drop the loop into

the device

Pulling down

the screw hole

part

Put the

slider in

Figure 2. Attach Device to Loop

Drive Tension

Device

Slider

Inside Mount Bracket

Outside Mount Bracket

#6 wood screw

wood screw

#4 wood screw

Figure 1. Parts

Nub

Part List (see Figure 1)

1. one assembled device

2. one slider

3. two brackets: one for inside mount

and one for outside mount

4. one 1/2 inch long #4 wood screw and

two 1 inch long #6 wood screws and

two wall anchors

5. one cable tie (not show)

6. instructions

Drive tension device

Figure 4. Put the Device in Place

Figure 3. Pull Shade Up

Pull either side of drive loop

Fig 3: After the shade has been completely lifted against

the head rail, install the cord tensioner per additional

instructions as close as possible to the headrail and on the

end of the drive loop that was pulled to raise the shade.

Fig 4: Route a cable tie through the oval shaped hole

and completely around the bundled up drive chain or

cord loop. Tighten securely.

Figure 5. Bundle the Loop and

the Device with a Cable Tie

Cable tie

Attach Device to Bead Chain or Cord Loop (see Figure 2)

Drop the bead chain or cord loop in the device. While pulling the screw

hole part down, insert the slider from the side into the center of device

and push up, into place. Now the device is attached to the loop. The

device can easily move along the loop by pulling down the screw hole.

Note to Shade Fabricators to Comply with ANSI/WCMA Standard,

Section 6.5.1.

Pull either side of the drive loop as shown in Figure 3 until the shade is

lifted completely up to the headrail. Using the specic side of the drive

loop that was pulled to raise the shade, attach the device as described

above. While pulling down on the screw hole of the device, slide the

device up as close as possible to the headrail as shown in Figure 4.

Route a cable tie through the oval shaped hole on the device and

completely around the bundled up drive chain or cord loop, and tighten

the cable tie securely as shown in Figure 5.

Summary of content (2 pages)

PAGE 1
INSTRUCTION FOR UNIVERSAL DRIVE TENSION DEVICE WARNING : It is imperative that the drive tension device for bead chain/cord loop be properly secured to the wall or window frame to reduce a child’s access to the bead chain/cord loop. Young children can wrap bead chain/cord loops around their necks and strangle. Always keep loops secured and out of the reach of children.
PAGE 2
Install Device You can install the device inside window casing with inside mount bracket, or outside window casing with outside mount bracket. Make sure the device is not placed in the path of the bottom rail or fabric. At the job site, use cutting pliers to carefully snip and remove the cable tie from the device. Slide the device to the bottom of the tool while pulling the screw hole in the device as shown in Figure 6.