Users Manual Part 3

Vehicle Monitoring and Locating System Mobile Video Computing Solutions LLC
Tow Truck Installation Procedures
40 September 21, 2021
System Checkout
1) Press INFO on remote to bring up
System Information page 1 (point
remote at front of MDVR).
2) Wait 1-2 minutes for the following
indications:
a) SIM-Card: EXIST
b) SIM Signal: 10 (or greater)
c) Dial Status: OK
d) Center Link: SUCCESSFUL
e) GPS-M: VALID
3) Exercise connections to all
IO_SENSOR inputs which were used
and observe proper response:
a) IO: 1: L=<4.5V; H=>4.5V
b) IO: 2: L=<4.5V; H=>4.5V
c) IO: 3: L=<4.5V; H=>4.5V
d) IO: 4: L=<4.5V; H=>4.5V
e) IO: 5: L=<4.5V; H=>4.5V
f) IO: 6: L=<4.5V; H=>4.5V
4) Press NEXT to go to page 2 and
verify:
a) Storage/Main shows a total of
about 900 GB and State is Rec’ing
5) Press RETURN to exit page.
MVCS Confirmation and Sign-off
1. Call MVCS System Monitoring Staff number (page 1).
2. Identify yourself as installer and the customer you are serving and that you need a
Confirmation and Sign-off on installation.
3. Wait for MVCS person to verify camera and GPS functionality and camera aiming.
Exercise any discrete inputs per MVCS person request. For the last step (MDVR must be
in final location in a level truck), when the MVCS person asks, reset the G-sensors using
the following procedure: