Owner's manual

GB Shuttle Manual 100316

SW 838023

Display and keyboard

Sensor to zero point distance

The level read-out (zero point) can be adjusted as required.

This is almost always required if the well was not empty dur-

ing initial startup.

Note: The learning function settings will be erased and

the relays will be deactivated if the zero point set-

ting is changed.

In this example, the level read-out is changed to be 1.50 ft

from the bottom of the well / tank.

Shuttle

will now read out - 0,50 m when the well is empty.

Set the new zero point with the arrow keys.

If the learning function has been activated, Shuttle

will de-

activate the learning function and erase the suspicious levels

that were found last time the learning function was activated.

The learning function must therefore both be started and

reactivated again.

If the relay outputs are conﬁgured for pump control, the

relays will be deactivated, but their limit settings will not be

erased. Also, delay settings and other settings will not be

erased.

2,00 m

0,50 m

0,00 m