User Guide

No. 99MBA038A
4-2
[Operating Procedures]
Table 4-1-1
No. Operation Screen display and remarks
1
Preparing the workpiece
Set the model workpiece on the XY table as shown
below, and focus on it.
–
2
Aligning the part coordinate system
For the aligning procedure, see Section 3.2 “Aligning
Part Coordinate System Using Edges as Reference”.
The explanation for the operations from
step 3 onward assumes that the part
coordinate system has been aligned.
3
Measurement function selection
Press
.
–
4
Changing measurement conditions
Press the [F3] function key corresponding to
.
–
5
Setting “Auto.MeasuringCompletion” to OFF
Press the [F3] key to set the
“Auto.MeasuringCompletion” to “OFF”.
Auto.MeasuringCompletion: OFF
: Press [F3] to switch the status.
6
Completion of changing measurement conditions
Press the [F5] function key corresponding to
.
–
7
Measuring edge (A)
Measure edge (A) at three or more points.
2
n
3
1
(A)
<Remarks>
Follow the information displayed on the
screen to perform the measurement.