User Manual

ManualsBrandsMitsumi Electric ManualsElectronics802.11abgn WLAN Module

User Manual

MITSUMI 802.11abgn WLAN Module

MODEL DWM-W034

The purpose of this manual is to explain correct way how to integrate module

DWM-W034 to the end product. It includes procedures that shall assist you to avoid

unforeseen problems. This manual presents information that shows how module

and OEM product, where module integrated, complies with regulations in certain

regions. Any modifications, not expressly approved by the manufacturer could void

the authority to operate in these regions.

The MITSUMI 802.11abgn WLAN Module, model DWM-W034 has to be installed

and used in accordance with the technical description/installation instructions

provided by the manufacturer.

For detail information concerning type approval of this module (e.g. where this

module is already pre-approved) please contact the authorized local distributor or

the manufacturer.

The system may only be implemented in the configuration that was authorized.

Note that any changes or modifications to this equipment not expressly approved

by the manufacturer could void the user’s authority to operate this equipment.

Summary of content (8 pages)

PAGE 1
User Manual MITSUMI 802.11abgn WLAN Module MODEL DWM-W034 The purpose of this manual is to explain correct way how to integrate module DWM-W034 to the end product. It includes procedures that shall assist you to avoid unforeseen problems. This manual presents information that shows how module and OEM product, where module integrated, complies with regulations in certain regions. Any modifications, not expressly approved by the manufacturer could void the authority to operate in these regions.
PAGE 2
Regulatory Information Operational Information Wireless Interoperability The end product integrating this module is designed to be interoperable with any wireless LAN product that is based on direct sequence spread spectrum (DSSS) and orthogonal frequency division multiplexing (OFDM) radio technology and to comply with the following standards. ･IEEE Std 802.11b Standard on 2.4GHz Wireless LAN ･IEEE Std 802.11g Standard on 2.4GHz Wireless LAN ･IEEE Std 802.11n Standard on 2.4GHz Wireless LAN ･IEEE Std 802.
PAGE 3
USA-Federal Communications Commission (FCC) This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance with the instructions, it may cause harmful interference to radio communications.
PAGE 4
other antenna or transmitter. Canada-Industry Canada (IC) This device complies with RSS 210 of Industry Canada. Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) This device must accept any interference, including interference that may cause undesired operation of this device.
PAGE 5
Europe-EU Declaration of Conformity and Restrictions Hereby, MITSUMI declares that this Mitsumi 802.11abgn WLAN Module DWM-W034 is in compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC. This equipment is marked with the symbol and can be used throughout the European community.
PAGE 6
- DFS and TPC must remain enabled to ensure product compliance with EC regulations. - To ensure compliance with local regulations, be sure to select the country in which the access point in installed. Remark: This module is fore a fixed application only. The OEM integrator will need to conduct full EMS testing in accordance with EN301 489-17 in the final use configuration. Caution: Exposure to Radio Frequency Radiation.
PAGE 7
NCC Warning Statement 低功率電波輻性電機管理辦法第十二條經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得擅自變更頻率、加大功率或變更原設計之特性及功能。第十四條低功率射頻電機之使用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，並改善至無干擾時方得繼續使用。前項合法通信，指依電信規定作業之無線電信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射性電機設備之干擾。在 5.25G ~5.35G 頻帶內操作之無線資訊傳輸設備僅適於室內使用模組認證合格標簽 (ID): “ CCXXxxLPyyyZz＂如果使用本模組之平台,無法在外部看見審驗合格標籤時,應在該平台的外部明顯標示 “內含射頻模 CCXXxxLPyyyZz” .
PAGE 8
legal communications or industrial and scientific applications. Radio devices using 5.25-5.35GHz bands are restricted to indoor use only.