Owner`s manual

9
 While holding the unit firmly, pull out the starter rope firmly until engine fires (indicated by a cough
from the engine).
 Move the choke lever to the open position "d" Fig 2.
 Pull the starter rope until the engine starts.
 Allow the engine to warm up before use. When cutting, always use the hedge trimmer on full
throttle.
HOT ENGINE STARTING
 Set the ignition switch to the start position "I" (RUN) Fig 3.
 Pull the starter rope until the engine starts.
 If the engine does not start after 5 pulls, use the cold start procedure.
OVERCHOKING
 Should the engine become flooded due to overchoking, turn the ignition switch off, unscrew the
spark plug, wipe it dry or replace, pull the recoil starter several times without the spark plug in
place and with choke in the open position. This will help clean and ventilate the combustion
chamber.
STOPPING THE ENGINE
 Set the engine to idling by releasing the throttle lever.
 Set the ignition switch to the off position ''O'' (STOP) Fig 3.
 If the engine fails to stop, set the choke lever to the closed position to stall the engine; do not use
the machine until the ignition switch is repaired.
RUNNING IN
 During the first ten hours of work, avoid running the engine at maximum speed for a prolonged
period until all the components have bedded in, after the engine has been run in, it will reach its
maximum power.