Installation & Assembly

Hardware:

Component:

Bolt M6x20mm x28

Flat Washer x4

Rubber Insert x16

Allen Wrench x1

Headboard x1

Footboard x1

Side Rail x2

Double Slat x4

Single Slat x8

Low Post x2

Before you start, here is some helpful advice:

1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step

instructions.

2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or

padded area, in the room that it is intended for. Approx assembly time: 45 minutes.

3.Please do not use any tools other than those provided or recommended in these instructions.

4.Please do not throw away any of the packaging or the instruction until you have checked all the components and

hardware and the furniture is fully assembled. Please ensure that the packaging is disposed of in a safe

environmentally friendly way.

5.Assemble all components loosely until advised to tighten. Depending on use, it may be necessary to tighten the

components from time to time, so please save the tools that has been provided.

6.Please keep all fitting out of reach of children.

TWIN BED

Page 1 of 3

PAGE 1
TWIN BED Before you start, here is some helpful advice: 1.We suggest you spend a short time reading through this leaflet and then follow the simple step by step instructions. 2.Owing to the size and weight of the bed, we recommend that it is assembled by two adults, on a carpeted or padded area, in the room that it is intended for. Approx assembly time: 45 minutes. 3.Please do not use any tools other than those provided or recommended in these instructions. 4.
PAGE 2
TWIN BED STEP 1: Insert Low Post (6) into Headboard (1) as shown. Attach by using Flat Washer (B) and Bolt (A) from the holes on the back of Low Post (6) and Headboard (1). Use Allen Wrench (D) to tighten Bolts (A) clockwise until secure at this step. 1 A B A 1 6 B D A Ba ck wit h ho l es A 6 Ax4 6 Bx4 Dx1 Hardware & Tool required STEP 2: Take out all Double Slats (4), Single Slats(5) and Side Rails(3) and place them as shown.
PAGE 3
TWIN BED STEP 3: Insert Bolts (A) into the bottom holes on the assembled Headboard (1&6) & Footboard (2) by hand. Leaving 0.3~0.4inch space of the thread of Bolts (A) as shown for inserting the notch of assembled Side Rails (3&4&5). Insert the notch of assembled Side Rails(3&4&5) into the space left on the Bolts (A). Screw Bolts (A) into the top holes on the assembled Headboard (1&6) & Footboard (2) as shown. Tighten Bolts (A) with Allen Wrench (D) after all assembled. 1 6 3 6 3 2 0.3~0.