Operation Manual

Table Of Contents

Recharging Battery:

1. Before charging, please check if the battery is properly mounted and turn on the

power switch.

2. Two ways to charge the battery:

A. Push the adaptor plug into d.c. jack at the side of the unit first, and then plug the

a.c end of the adaptor into the a.c. power outlet on the wall. (Please connect the

adaptor to the unit first before connecting to the a.c power outlet.)

B. Make sure the docking station is installed properly, place the unit to the docking

station, make sure the contact points at the back of the unit is contacted with the

contact plate at the docking station.(See page 15 proof test)

3. When charging, the LED indicator below the “ ” (Power) on M680GMA (as

above diagram) will flash green, and it will stay green when the cleaner has been

uninterruptedly charged for 4~6 hours

4. To make sure the battery always at full charged status, the unit will be charged 15

min every hour after full.

5. When the M680GMA is in the "Battery Low" situation, “ ” (Power) will stay in

the RED.

INSTALLATION GUIDE

Adaptor Plug

D.C. jack